USIP OSP Tutorial - Simulation Authoring 1.0
Help!

Step 12b. Creating universal sections - Part B. Adding a Meeting

a.) Select 'Meeting' from the pulldown and then click the 'Add Section' button.

Select Meeting

b. Customize the Meeting room as shown below, and then select 'Save and Add Section to Conversants'

Tip: Make sure you select the conversation 'orange_chat' that you created before.

customize market

 

Tip: You will not see the 'Market' listed in the universal sections. This is because one selects the actors that can participate in a meeting room, and not all of them may have been selected. These selections will show up when you look at the individual actors, which is the next step.

c.) Use the control in the upper right hand corner to to change phase to the completed phase.

Tip: First select the phase 'Completed' and then push the 'Change Phase' button.

Change Phase 1 to Change Phase 2 to Change Phase 3

 

d.) Observe that 'AAR' has already been added to the the 'completed' phase as shown below.

AAR in Completed Phase

e.) Add the 'Cast' phase, as done before, to this 'Completed' phase.

Tip: We are not adding the 'Meeting' to the Completed phase, since by then the meeting has completed.

f.) Change phase back to the 'Started' phase.

g..) Select the link 'Next Step: Customize Sections for the Actor Orange Salesman' to move on to the next step.

 

 

<-- back
|| table of contents ||
next -->
To report corrections or errors, please click here.
(If the above link does not work, you can also just send an email to tech@opensimplatform.org with the subject heading 'Problem on Tutorial Page Simulation Authoring Page 12b'.)

 

The USIP Open Simulation Platform is a USIP Open Source Software Project.